Find great deals for Omron E5ax Temperature Controller E5ax-a-f. Shop with confidence on eBay!. E5AX-VAA Omron Automation and Safety Controllers datasheet, inventory, & pricing. E5AX-A by Omron | OMRON TEMPERATURE CONTROLLER | Shipping to + countries worldwide.

Author: Negis Vudok
Country: Egypt
Language: English (Spanish)
Genre: Spiritual
Published (Last): 25 October 2010
Pages: 311
PDF File Size: 14.66 Mb
ePub File Size: 1.16 Mb
ISBN: 777-8-42277-297-1
Downloads: 18784
Price: Free* [*Free Regsitration Required]
Uploader: Moogukree

The count value for the fully open position will be set. After that, the Temperature Controller automatically adjusts the PID constants using the limit cycle method.

Actual displays vary with models and switch settings. Temperature Controller must be omfon if recovery is not made by turning power off once and on again. This function is used to shift the temperature display from the measured value by a desired value, as shown by the examples in the following table: Up Key Press to increase the main setting or other parameters.

Derivative Time Rate Time: If this difference is too great, a drastic change will result. The output value will change according to the difference between the set value and the present value when the proportional band is changed during control operation.

Not displayed in automatic output mode. Note 1 Press a. The maximum total cable length must not exceed the following limits. Set the alarm value by using the Up and Down Keys while al is displayed. The following table shows the messages that may be displayed: Use lead wires having a small resistance for lmron resistance thermometers.


Turn on power and press the Level Key for at least two seconds. To enter the mode, simultaneously press the Up and Down Keys for at least one second. The terminal block of the Temperature Controller is constructed so that the lead wires can be connected to all the terminals from the same direction.


Sequenced Circuits Several seconds are required until the relay in turned ON after power has been supplied to the Temperature Controller. Attach the two mounting brackets supplied with E5AX on the top and bottom of the Temperature Controller. ON Sends alarm signal in accordance with the set alarm mode.

AT indicator flashes Limit Cycle Method: RS and terminals are shown. Refer to page 9. Main setting, set alarm value, process value, error codes, etc. Input shift value — fr—l Count value Fully closed position Press a.

Omron E5ax Temperature Controller E5ax-a-f

All units are in millimeters unless otherwise indicated. Therefore, take this time delay into consideration when designing sequenced circuits which incorporate a Temperature Controller. It can be set in a range from 0. Any of these condition will affect product life. Remove the internal mechanism from the housing. Recommended panel thickness is 1 to 8 mm.

  FC0056702 00A PDF

Omron E5ax Temperature Controller E5ax-a-f | eBay

When the temperature exceeds or falls below the set alarm value, the corresponding alarm output is produced and the ALM indicator on the front panel lights. Press the Display Key. The display level mode changes as shown below.

Level 0 is the initial and is automatically entered at power application. Omgon Mode Selector SW Not displayed when the alarm is disabled SW set to 0 or 9. The factory setting is 0. Simultaneously press the Up and Down Keys for at least one second.

Automatic Output Mode In automatic output mode, the control will function automatically.

When the auto-tuning indicator turns off, the auto-tuning is terminated and PID constants are renewed. Optimum PID control with feed-forward control circuitry. Moreover, avoid locations subject to heavy vibration or shock, water or oil o,ron, or high temperatures.

Displayed only when the motor calibration mode is entered.